Table of Contents
Advertisement
DSTREAM-XT Getting Started Guide
3 Set up your DSTREAM-XT system
This chapter contains instructions about connecting the DSTREAM-XT system to your host
computer and target system.
3.1 Install the USB drivers for the DSTREAM-XT system
on Windows
To use the DSTREAM-XT system with a USB connection, for your operating system, install the USB
device drivers provided with Arm
Before you begin
Ensure you have:
• Installed Arm Development Studio. For more information, see the
Getting Started
Guide.
• Administrative privileges on your host computer.
About this task
The drivers for the DSTREAM-XT system are optionally installed as part of the installation process
for Arm Development Studio. If you have skipped the driver install process in Arm Development
Studio, follow these steps to install them.
Procedure
1. Using administrative privileges, run the driver_install.bat batch file that is available in
<Arm_Development_Studio_install_directory>\sw\driver_files directory.
2. In the Arm Development Studio Driver Installation Wizard, click Next and follow the steps.
During installation, you might receive warnings such as Windows can't verify
the publisher of this driver software. You can safely ignore these warnings and
continue with the installation.
3. After the drivers are installed, click Finish.
Results
The USB drivers are now installed on your host computer.
Related information
Connect and power up the DSTREAM-XT system
Copyright © 2021 Arm Limited (or its affiliates). All rights reserved.
Development Studio 2021.1 or later.
®
on page 26
Non-Confidential
Document ID: 102443_1.0_00_en
Version 1.0
Set up your DSTREAM-XT system
Arm Development Studio
Page 25 of 38
Advertisement
Table of Contents
