ARM DSTREAM-XT Getting Started Manual page 28

DSTREAM-XT Getting Started Guide
3. Power up the DSTREAM-XT system.
When you power up the DSTREAM-ST unit and XT probe, both units follow a boot sequence.
The LEDs identify the progress of the boot sequence. For more information, see
system boot sequence.
• Arm recommends that both the DSTREAM-ST unit and XT probe are
powered-up simultaneously. Powering simultaneously ensures that the
DSTREAM-ST unit correctly detects the XT probe during its boot sequence.
• If you need to reset the DSTREAM-XT system, press the reset button on
the rear of the DSTREAM-ST unit. When a DSTREAM-ST unit is connected
in a DSTREAM-XT system, the reset button on the DSTREAM-ST unit re-
initializes both the DSTREAM-ST unit and the XT probe.
4. If you are connecting across an Ethernet network, configure the Ethernet and internet protocol
settings for your DSTREAM-ST unit. To configure these settings, use the
Configure IP view in Arm Development Studio.
You can also use the Debug Hardware Configure IP view to assign a name for the DSTREAM-
ST unit.
5. Connect the DSTREAM-XT system to the target hardware. Use the appropriate cables and
adapters for the target debug and trace connector (or connectors). Some targets have debug
and trace on a single connector, and some targets split them between two connectors. Each
connector, and the appropriate cable to use for that connector, is described in
connectors in the Arm DSTREAM-XT System and Interface Design Reference Guide.
• When connecting the DSTREAM-XT system to target hardware, to avoid
damaging the target or debug hardware, ensure that the debug and
trace connector (or connectors) on the target use pinouts supported by
DSTREAM-XT. For supported pinout information, see the
XT System and Interface Design Reference
• If your target performs debug and trace using a single PCIe connector,
connect the XT probe to the target using the 98-way ribbon cable and the
appropriate DSTREAM-XT adapter:
Copyright © 2021 Arm Limited (or its affiliates). All rights reserved.
Non-Confidential
Document ID: 102443_1.0_00_en
Set up your DSTREAM-XT system
DSTREAM-XT
Debug Hardware
Target interface
Arm DSTREAM-
Guide.
Version 1.0
Page 28 of 38