Polaris RZR XP 1000 2017 Service Manual page 493

Problem: Screen missing pixels, LCD screen flaw, software glitch or problem
STEP
Power cycle bike by switching ignition on and off with main power
switch in fairing.
1
Did you find and repair the condition?
Update display with newest software available.
Refer to Update Software / Maps, page 11.31 for instructions on how to
2
update/reflash software.
Is display working properly?
1. Remove and reinstall the 5amp fuse labeled INST in the main fuse
box under the left side upper panel.
3
Refer to Fuse Box, page 11.59
Did you find and repair the condition?
Replace display with known good display.
4
Did you find and repair the condition?
GPS Antenna Troubleshooting
1. Unplug connector from GPS antenna and verify all contacts are securely seated in the connector.
2. Turn ignition on and make the following measurements on the antenna connector:
WIRING
Power
3. If antenna connector has 0Vdc supplied, check harness for loose connection or breaks in wiring. Check for power
at SW PWR fuse in fuse box.
4. If antenna connector shows proper voltage, check operation of GPS. If GPS still is not functioning, proceed to step
5.
5. Turn the ignition off and make the following measurements on the antenna connector:
6.
WIRING
CAN
7. If resistance value is out of spec, check for breaks in yellow/green CAN wiring.
8. If all values are within specification, replace GPS antenna with new unit.
9928492 R04 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
ACTION
CONNECTION TO MEASURE
Between Pins 4 and 3
CONNECTION TO MEASURE
Between Pins 1 and 2
ELECTRICAL
YES NO
Go to Step 2 Go to Step 2
Confirm
display
Go to Step 3
operation and
continue use.
Go to Step 2 Go to Step 4
Repeat
Go to Step 2
Diagnosis
VOLTAGE SPECIFICATION
12Vdc (Battery Voltage)
RESISTANCE SPECIFICATION
60 Ohms
11
11.33