Rear Brakes; Pad Removal - Polaris RZR XP 1000 2017 Service Manual

Table of Contents

REAR BRAKES

1. Elevate and support rear of vehicle.

Use care when supporting vehicle so that it does not tip

or fall. Severe injury may occur if machine tips or falls.

2. Remove the rear wheel.

3. Loosen pad adjuster screw 2-3 turns.

4. Remove the lower radius rod outer mounting bolt

nut and washer from the bearing carrier. Swing

radius rod down. Discard the nut.

9928492 R04 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual

5. Remove the two caliper mounting bolts

caliper off the brake disc.

When removing caliper, be careful not to damage brake

line. Support caliper to avoid kinking or bending brake

6. Push caliper piston into the caliper bore slowly using

a C-clamp or locking pliers with pads installed.

Brake fluid will be forced through compensating port

into master cylinder fluid reservoir when piston is

pushed back into caliper. Remove excess fluid from

reservoir as required.

BRAKE SYSTEM