Polaris RZR XP 1000 2017 Service Manual page 303

3. Remove the bell crank nut
e
4. Remove E-clip that retains spring and flat washers
r t
and gear switch . Remove the switch.
5. Remove the sector cover bolts
u
sector cover .
NOTE
Removal can be aided by using your thumbs to press in
on the shafts while pulling out the cover with your
fingers.
6. Remove the compression spring
o
7. Remove the detent star
fits onto the splined shaft with the raised edge facing
outward for reassembly.
a
8. Remove the spacer .
s
9. Remove the shift shaft , detent pawl
f g
sector gears and .
NOTE
Note the timing marks on the shift gears for reassembly
purposes.
h
10. Remove the O-rings from each shaft and discard.
Use new O-rings upon assembly.
9928492 R04 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
q w
and bell crank .
y
and remove the
i
.
. Note how the detent star
d
and the shift
11. Remove all the transmission case bolts. Using suit-
able pry bars, remove the cover using the designated
pry points (indicated by the black arrows in the illus-
tration below).
CAUTION
Do not pry on case sealing surfaces.
Use only the designated pry points on the
transmission.
12. Lift up on the shift shaft rail
assembly rearward to allow the shift fork pins
removed from the shift drum
drum from the transmission housing.
TRANSMISSION
6
j
and move the rail
k
to be
l
. Remove the shift
6.15