Table of Contents
Advertisement
ENGINE / COOLING SYSTEM
13. Verify cam timing is correct. Flywheel TDC mark
should still be aligned (see Step 1) and cam sprocket
markings should line up as shown.
3.78
14. If timing marks are not aligned, remove sprockets
and correct alignment.
15. Remove the Cylinder Holding & Camshaft Timing
Plate (PU-50563) from the end of the camshafts.
16. Rotate the engine using the flywheel and install the
remaining bolt in each camshaft sprocket. Torque the
sprocket bolts to specification.
TORQUE
Camshaft Sprocket Bolts:
14 ft-lb (19 Nm)
17. Rotate the engine using the flywheel and torque the
remaining sprocket bolts to specification.
18. Install the front camshaft carrier
retaining bolts.
19. Install the fixed cam chain guide
bolts.
9928492 R04 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
o
and two outer
a
and two retaining
© Copyright Polaris Industries Inc.
Advertisement
Table of Contents
Troubleshooting
