Polaris RZR XP 1000 2017 Service Manual page 297

w
13. Remove the four bolts (
lower radius rods to the bearing carriers (left and
right side). Discard nuts and replace with new upon
assembly. Allow the radius rods swing downward.
14. Remove both lower shock bolts (left and right side)
while supporting the trailing arms from underneath.
Lift training arms up and swing trailing arms outward
to remove the drive shafts from the transmission.
15. Maneuver the drive shafts out of the vehicle frame.
Reinstall the lower shock bolts
arms up during the rest of the removal procedure.
9928492 R04 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
attaching the upper and 16. Place a spacer or support between the vehicle frame
17. Remove vent hose from transmission.
18. Remove the gear position switch connector
e
to hold the trailing
19. Remove
and engine to hold the engine up in position.
t
speed sensor connector
r
sensor connector , shift bracket bolts and shift
u
bracket , shift cable clevis pin and washer
the transmission.
the wire ties retaining
transmission and mounts.
TRANSMISSION
y
,
, crankshaft position
i
from
6
harness to
6.9