Polaris RZR XP 1000 2017 Service Manual page 123

6. Rotate water pump drive tab
angle of the drive slot in the engine.
CAUTION
The water pump drive tab and slot must be aligned
properly during installation. Severe engine or water
pump damage will occur if the tab and slot are not in
alignment during water pump installation.
7. Maneuver water pump up through the access hole in
the skid plate on the RH side of the vehicle.
8. Slide water pump into engine crankcase.
9. Be sure water pump is fully seated and the drive tab
and slot are properly engaged.
10. Install the three water pump mounting bolts
and torque to specification.
NOTE
Install different bolt lengths as shown.
TORQUE
Water Pump Mounting Bolts:
7 ft-lb (10 Nm)(Apply Loctite® 204™ to bolt threads)
9928492 R04 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
r
so it matches the 11. Install the four coolant hoses
12. Install the right rear lower shock bolt and new nut.
13. Install the right rear wheel. Torque wheel nuts to
t y
&
14. Connect the (-) negative battery cable.
15. Fill and bleed cooling system as outlined in this
16. Install the hood, engine service panel and seats.
ENGINE / COOLING SYSTEM
the water pump. Be sure orientation and routing are
correct.
Torque mounting bolt to specification.
TORQUE
Rear Shock Mounting Bolt:
70 ft-lbs (95 Nm)
specification.
TORQUE
Wheel Nuts:
120 ft-lbs (163 Nm)
chapter.
u a
– that attach to
3
3.17