Polaris RZR XP 1000 2017 Service Manual page 378

Table of Contents

STEERING / SUSPENSION

14. Remove the front trailing arm bolt

15. Remove trailing arm from vehicle. Visually inspect

trailing arm, bushings, o-rings and spherical bearing

for wear. If bearing requires replacement, refer to

"Trailing Arm Spherical Bearing Replacement".

16. Replace trailing arm if physically damaged.

17. Reverse this procedure to reinstall rear trailing arm.

Use new fastener nuts upon installation of the rear

trailing arm and bearing carrier.

18. Torque all fasteners to specification.

Trailing Arm to Main Frame:

(Trailing arm spherical bearing bolt)

70 ft-lb (95 Nm)

Rear Shock Mounting Bolts:

70 ft-lbs (95 Nm)

Rear Stabilizer Bar Linkage:

40 ft-lbs (54 Nm)

Radius Rod Mounting Bolts:

M10: 40 ft-lb (54 Nm)

M12 (outer): 50 ft-lb + 90° (68 Nm + 90°)

Bearing Carrier to Trailing Arm Bolts:

42 ft-lb (54 Nm)

Rear Brake Caliper Mounting Bolts:

40 ft-lbs (54 Nm)

Rear Wheel Hub Castle Nut:

110 ft-lbs (149 Nm)

120 ft-lbs (163 Nm)

. Discard the

Upon rear trailing arm installation, test vehicle at low

speeds before putting into service.

9928492 R04 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual

Troubleshooting