Table of Contents
Advertisement
TRANSMISSION
4. Remove the retaining clip
5. Disconnect the shift cable from the shifter.
6. Remove the shifter from the vehicle.
SPHERICAL BEARING REMOVAL
1. Remove the snap ring
bearing.
The spherical bearing orientation inside the shift lever is
important for proper function. Note the alignment
the marks in the spherical bearing with the marking on
the shift lever
2. Remove the spherical bearing from the shift lever.
6.4
u
from the shifter.
i
retaining the spherical
NOTE
SHIFT LEVER INSTALLATION (GOLD
METALLIC LE)
1. Add Loctite 603 on completely around the outer
surface of the spherical bearing. Install the spherical
bearing into the shift lever.
The spherical bearing orientation inside the shift lever is
important for proper function. Note the alignment
the marks in the spherical bearing with the marking on
2. Once the spherical bearing marks are aligned with
the mark on the shift lever
After the snap ring is installed, you should be able to
move the spherical bearing with your finger tip. If the
bearing will not move, it should be replaced.
3. Install the shifter to the mounting bracket.
4. Install the retaining clip
the bracket.
o
of
5. Install the shift cable to the shift lever.
9928492 R04 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
NOTE
the shift lever
o
, install the snap ring
IMPORTANT
u
securing the shift lever to
© Copyright Polaris Industries Inc.
o
of
i
.
Advertisement
Table of Contents
Troubleshooting
