Polaris RZR XP 1000 2017 Service Manual page 318

TRANSMISSION
17. Install the idler gear shaft assembly
2*
assembly , and input shaft assembly
transmission housing, all at the same time.
18. Install the rear output shaft assembly
19. Assemble the shift
disassembled.
Both shift forks need to be orientated the same way, so
that the shift fork pins are both offset to the same side
of the rail.
6.30
2&
, gear cluster
2 (
into the
3)
.
shaft rail if previously
NOTE
20. Install the shift shaft rail
transmission housing as an assembly. Be sure the
shift forks are engaged into the engagement dogs.
Shift fork pins should be offset towards the input shaft
as shown above
21. Inspect the shift drum for any damage or wear.
Inspect the splines of the shift drum.
22. Install the shift drum into the transmission housing.
Lift up on the shift shaft rail and move the rail
assembly towards the shift drum to allow the shift fork
ends to be installed into the shift drum.
9928492 R04 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
3!
and shift forks into the
NOTE
3@
.
© Copyright Polaris Industries Inc.