Toyota 2VZ-FE Manual page 70

EM-68
ENGINE MECHANICAL – Cylinder Block
39. REMOVE ENGINE AND TRANSAXLE ASSEMBLY FROM
VEHICLE
(a) Attach the engine chain hoist to the engine hangers.
(b) Remove the clamp bolts of the PS oil cooler pipes.
(c) Remove the four nuts, bolt and RH mounting insulator.
(d) Remove the through bolt, nut, four bolts and LH
mounting insulator.
(e) Remove the three bolts and LH mounting bracket.
(f) Lift the engine out of the vehicle slowly and carefully.
NOTICE: Be careful not to hit the PS gear housing or
neutral start switch.
(g) Make sure that the engine is clear of all wiring, hoses
and cables.
(h) Place the engine and transaxle assembly onto the
stand.
40. (A/T)
REMOVE STARTER (See page ST–5)
41. SEPARATE ENGINE AND TRANSAXLE
(See page MT–8 or AT–15)