Table of Contents
Advertisement
TR–70
INSPECTION PROCEDURE
Check starter operation.
Check voltage between terminals STA and E1 of ECU circuit.
Replace ECU. *
* When diag. code 43 is not displayed, proceed to next circuit inspection shown on matrix chart
(See page TR–23).
ENGINE TROUBLESHOOTING
–
Circuit Inspection
Replace air flow meter.
Check starter circuit.
Turn ignition switch STA.
Measure voltage between terminals STA and E1 of
ECU connector.
Voltage: 6 V or more
Check harness and connector between ECU
and terminal STA (50) of starter.
Hide quick links:
Advertisement
Table of Contents
