Toyota 2VZ-FE Manual page 54

EM-52
ENGINE MECHANICAL – Cylinder Heads
(d) Insert a service bolt (A) into the service hole of the
camshaft sub–gear.
(e) Using a screwdriver, align the holes of the camshaft
driven gear and sub–gear by turning camshaft subgear
clockwise, and install a service bolt (B).
NOTICE: Be careful not to damage the camshaft.
4. INSTALL CAMSHAFTS
NOTICE: Since the thrust clearance of the camshaft is
small, the camshaft must be held level while it is being
installed. If the camshaft is not level, the portion of the
cylinder head receiving the shaft thrust may crack or be
damaged, causing the camshaft to seize or break. To
avoid this, the following steps should be carried out.
A. Install intake camshaft of RH cylinder head
(a) Apply MP grease to the thrust portion of the camshaft.
(b) Place the intake camshaft at 905 angle of timing mark
(two pointed marks) on the cylinder head.
(c) Apply seal packing to the No.1 bearing cap as shown.
Seal packing: Part No. 08826–00080 or equivalent
(d) Install the five bearing caps in their proper locations.