Toyota 2VZ-FE Manual page 219

LU–14
LUBRICATION SYSTEM –
INSTALLATION OF OIL PUMP
(See page LU–8)
1. INSTALL OIL PUMP
(a) Remove any old packing (FIPG) material and be careful
(b) Apply seal packing to the oil pump as shown in the
Seal packing: Part No. 08826–00080 or equivalent
HINT: Avoid applying an excessive amount to the surface.
(c) Place a new O–ring in position on the cylinder block.
(d) Engage the spline teeth of the oil pump drive gear with
Oil Pump
not to drop any oil on the contact surfaces of the oil
pump and cylinder block.
Using a razor blade and gasket scraper, remove all
the old packing (FIPG) material from the gasket
surfaces and sealing grooves.
Thoroughly clean all components to remove all the
loose material.
Using a non–residue solvent, clean both sealing
surfaces.
figure.
Install a nozzle that has been cut to a 2–3 mm (0.08
– 0.12 in.) opening.
Parts must be assembled within 5 minutes of
application. Otherwise the material must be
removed and reapplied.
Immediately remove nozzle from the tube and
reinstall cap.
the large teeth of the crankshaft, and slide.