Table of Contents
Advertisement
ENGINE MECHANICAL – Cylinder Heads
(e) Apply a light coat of engine oil on the threads and under
the heads of bearing cap bolts.
(f)
Install and uniformly tighten the eight bearing cap bolts
in several passes in the sequence shown.
Torque: 160 kg–cm (12 ft–lb, 16 N m)
(g) Remove the service bolt (B).
5.
CHECK AND ADJUST VALVE CLEARANCE
(See page EM–9)
Turn the camshaft and position the cam lobe upward, and
check and adjust the valve clearance.
Valve clearance (Cold):
Intake
Exhaust
6.
INSTALL CAMSHAFT OIL SEALS
(a) Apply MP grease to a new oil seal lip.
(b) Using SST, tap in the oil seals.
SST 09223–46011
7.
INSTALL SPARK PLUG TUBE GASKETS
Install the six tube gaskets.
0.13–0.23 mm (0.005–0.009 in.)
0.27–0.37 mm (0.011–0.015 in.)
EM-55
Hide quick links:
Advertisement
Table of Contents
