Toyota 2VZ-FE Manual page 28

EM-26
ENGINE MECHANICAL – Timing Belt
(f) Using SST, align the knock pin hole of the camshaft with
the knock pin groove of the pulley and install the knock
pin.
SST 09278–54012
(g) Using SST, install and torque the bolt.
SST 09249–63010 and 09278–54012
Torque: 760 kg–cm (55 ft–lb, 75 N m)
HINT: Use a torque wrench with a fulcrum length of 340 mm
(13.39 in.).
12. SET TIMING BELT TENSIONER
(a) Place a plate washer between the tensioner and a
block.
(b) Using a press, slowly press in the push rod using
100–1,000 kg (220–2,205 lb, 981–9,807 N) of pressure.
(c) Align the holes of the push rod and housing, pass a 1.27
mm hexagon wrench through the holes to keep the
setting position of the push rod.
(d) Release the press.
(e) Install the dust boot to the tensioner.
13. INSTALL TIMING BELT TENSIONER
(a) Install the tensioner with the two bolts.
Torque: 270 kg–cm (20 ft–lb, 26 N m)