Toyota 2VZ-FE Manual page 55

ENGINE MECHANICAL – Cylinder Heads
(e) Apply a light coat of engine oil on the threads and under
the heads of the bearing cap bolts.
(f) Install and uniformly tighten the ten bearing cap bolts in
several passes in the sequence shown.
Torque: 160 kg–cm (12 ft–lb, 16 N m)
B. Install exhaust camshaft of RH cylinder head
(a) Apply MP grease to the thrust portion of the camshaft.
(b) Align the timing marks (two pointed marks) of the
camshaft drive and driven gears.
(c) Place the exhaust camshaft on the cylinder head.
(d) Install the four bearing caps in their proper locations.
(e) Apply a light coat of engine oil on the threads and under
the heads of the bearing cap bolts.
(f) Install and uniformly tighten the eight bearing cap bolts
in several passes in the sequence shown.
Torque: 160 kg–cm (12 ft–lb, 16 N m)
(g) Remove the service bolt (B).
C. Install intake camshaft of LH cylinder head
(a) Apply MP grease to the thrust portion of the camshaft.
(b) Place the intake camshaft at 90° angle of timing mark
(one pointed mark) on the cylinder head.
EM-53