Toyota 2VZ-FE Manual page 193

COOLING SYSTEM – Water Pump
7. REMOVE WATER PUMP
(a) Remove the seven bolts.
(b) Remove the water pump by prying a screwdriver
between the water pump and cylinder block.
INSPECTION OF WATER PUMP
INSPECT WATER PUMP
Turn the pulley and check that the water pump bearing
moves smoothly and quietly.
INSTALLATION OF WATER PUMP
(See page CO–6)
1. INSTALL WATER PUMP
(a) Remove any old packing (FIPG) material and be careful
not to drop any oil on the contact surfaces of the water
pump and cylinder block.
Using a razor blade and gasket scraper, remove all
the old packing (FIPG) material from the gasket
surfaces and sealing groove.
Thoroughly clean all components to remove all the
loose material.
Using a non–residue solvent, clean both sealing
surfaces.
(b) Apply seal packing to the water pump groove.
Seal packing: Part No. 08826–00100 or equivalent
Install a nozzle that has been cut to a 2–3 mm
(0.08–0.12 in.) opening.
HINT: Avoid applying an excessive amount to the surface.
Parts must be assembled within 5 minutes of
application. Otherwise the material must be
removed and reapplied.
Immediately remove nozzle from the tube and
reinstall cap.
(c) Install the water pump with the seven bolts.
Torque: 200 kg–cm (14 ft–lb, 20 N m)
2. INSTALL WATER INLET AND THERMOSTAT
(See steps 1 to 3 on page CO–10)
CO–7