Table of Contents
Advertisement
EM-60
ENGINE MECHANICAL – Cylinder Heads
26. INSTALL EGR PIPE
Install a new gasket and the EGR pipe with the two bolts and
union nut.
Torque:
Bolt
Nut
27. INSTALL THROTTLE BODY
(See steps 1 and 2 on page FI–43)
28. INSTALL ISC VALVE
(See steps 1 to 3 on page FI–45)
29. INSTALL ALTERNATOR (See page CH–8)
30. INSTALL FRONT EXHAUST PIPE
(See step 14 on page EM–96)
31. INSTALL RH ENGINE UNDER COVER
32. INSTALL AIR CLEANER HOSE
33. INSTALL CRUISE CONTROL ACTUATOR
(See step 27 on page EM–97)
34. INSTALL ACCELERATOR CABLE, AND ADJUST IT
35. (A/T)
CONNECT THROTTLE CABLE, AND ADJUST IT
36. INSTALL SUSPENSION UPPER BRACE
(See step 35 on page EM–98)
37. FILL WITH ENGINE COOLANT (See page CO–5)
38. CONNECT CABLE TO NEGATIVE TERMINAL OF
BATTERY
39. START ENGINE AND CHECK FOR LEAKS
40. ADJUST IGNITION TIMING (See on page IG–13)
Ignition timing:
10° BTDC @ idle
(w/ Terminals TE1 and E1 connected)
41. PERFORM ROAD TEST
Check for abnormal noise, shock, slippage, correct shift
points and smooth operation.
42. RECHECK ENGINE COOLANT LEVEL AND OIL LEVEL
185 kg–cm (13 ft–lb, 18 N m)
800 kg–cm (58 ft–lb, 78 N m)
Hide quick links:
Advertisement
Table of Contents
