Toyota 2VZ-FE Manual page 34

EM-32
ENGINE MECHANICAL – Cylinder Heads
24. REMOVE WATER BY–PASS OUTLET
(a) Disconnect the following connectors and hose:
(1) Cold start injector time switch connector
(2) Water temperature sensor connector
(3) Heater water by–pass hose
(b) Remove the three nuts, water by–pass outlet and
gasket.
(c) Remove the two bolts and crossover pipe heat insulator
from the water by–pass outlet.
25. REMOVE CYLINDER HEAD REAR PLATE
Remove the two bolts and rear plate.
26. REMOVE INTAKE MANIFOLD
(a) Remove the two bolts and No.2 idler pulley bracket stay.
(b) Remove the eight bolts, four nuts, intake manifold and
two gaskets.
27. REMOVE RH EXHAUST MANIFOLD
(a) Disconnect the main oxygen sensor connector.
(b) Remove the three nuts and outside heat insulator.