Toyota 2VZ-FE Manual page 95

ENGINE MECHANICAL – Cylinder Block
INSTALLATION OF ENGINE
(See page EM–61
1. ASSEMBLE ENGINE AND TRANSAXLE
(See page MT–8
2. (A/T)
INSTALL STARTER (See page ST–5)
3. INSTALL ENGINE AND TRANSAXLE ASSEMBLY IN
VEHICLE
(a) Attach the engine chain hoist to the engine hangers.
(b) Lower the engine into the engine compartment.
Tilt the transaxle downward, lower the engine and clear the
LH mounting.
NOTICE: Be careful not to hit the PS gear housing or neu-
tral start switch.
(c) Keep the engine level, and align RH and LH mounting
with the body bracket.
(d) Attach the RH mounting insulator to the mounting
bracket and body, and temporarily install the four nuts
and bolt.
(e) Temporarily install the No.2 mounting stay bolt (A).
(f) Install the LH mounting bracket to the transaxle case
with the three bolts. Torque the bolts.
Torque: 530 kg–cm (38 ft–lb, 52 N m)
(g) Attach the LH mounting insulator to the mounting
bracket with the three bolts, and install and torque the
four bolts and through bolt.
Torque:
Bolt
Through bolt 890 kg–cm (64 ft–lb, 87 N m)
to 63)
or AT–15)
530 kg–cm (38 ft–lb, 52 N m)
EM-93