Table of Contents
Advertisement
5.
Use the 3-mm Allen wrench to fit and tighten the 3 PEEK ion block
support securing screws.
Look through the PEEK ion block support as you tighten the
Tip:
securing screws. Ensure that neither hexapole spring buckles and
touches a hexapole rod.
6.
Fit the ion block assembly to the PEEK ion block support (see
the ion block assembly to the source assembly" on page
Hexapole spring
Hexapole rod
TP02659
Cleaning the source hexapole assembly
"Fitting
5-43).
5-51
Advertisement
Table of Contents
