Direct Access - VETRON 5300 Instruction Book

02. MACHINE DESCRIPTION

10. DIRECT ACCESS

NOTICE!
It is possible to create operator´s direct access to one program parameter via the control
panel.
The direct access parameter is permanently shown in the display. The manipulations by
the operator are not saved in the program and will be reset after program change or when
the machine is turned o .
10
By turning the JOG KEY
The following parameters can be displayed:
» OFF
» Thread tension
» Stitch length
» Maximum speed
» Top feed stroke
» Top feed pressure
» Bobbin thread counter (only display)
» Edge guide distance
» Current sewing speed (only display)
» Current needle position in degrees (only display).
07/2020
24
VETRON 5300 - POST BED MACHINE - INSTRUCTION BOOK
P 000
T E T S
the value can be adjusted directly.
30%
ESC
1