Thread Tension - VETRON 5300 Instruction Book

05. PROGRAMMING
04. PROGRAM PARAMETER
-3-14
NR. PARAMETER
»

THREAD TENSION

ADVICE!
Thread tension
The thread tension on conventional machines is adjusted with a spring. The reproduction of the desired thread
tension is di cult. The VETRON sets the thread tension with a step motor. The task of the tension spring is taken over
by a elastomer. A second thread tension on conventional machines needs an additional tension unit.
The VETRON accomplish the 2
030 Thread tension A 1
031 Thread tension A 2
Thread tension B 1
032
(Two needle machine)
Thread tension B 2
033
(Two needle machine)
Thread tension level increase / decrease
034
based on material thickness
07/2020
44
VETRON 5300 - POST BED MACHINE - INSTRUCTION BOOK
DESCRIPTION
thread tension by increasing the tension.
nd
Main thread tension in program.
Setting range 0 to 100 %.
Higher thread tension than the main program.
Setting range 0 to 100 %.
The connection with the higher thread tension can be done by pushing button
or or when the 2
1
Main thread tension in program.
Setting range 0 to 100 %.
Higher thread tension than the main program.
Setting range 0 to 100 %.
The connection with the higher thread tension can be done by pushing button
or or when the 2
1
Two function are available.
Function 1 = OFF (no change on di erent material thickness)
Function 2 = % (lower percentage = less thread tension increase)
Automatic thread tension adjustment depends on material thickness
The tension will be adjusted with the information received from the material
thickness recognition. You can activate this function with the parameter 034.
With a lower percentage the increase will be less than with a higher percentage.
top feed stroke is activated.
nd
top feed stroke is activated.
nd
(higher percentage = more thread tension increase)
1
4
2
3
,
3
,
3