Table of Contents
Advertisement
05. PROGRAMMING
04. PROGRAM PARAMETER
-5-14
NR. PARAMETER
»
MAXIMUM ROTATION SPEED
041 Maximum speed
042 Softstart stitch count
NR. PARAMETER
»
FOOT PRESSURE CONTROL
ADVICE!
Automatic foot pressure control
On conventional machines the foot pressure is generated by a spring and will be adjusted seldom. The VETRON also
generates the foot pressure with a spring, but the spring is pre-stressed by a step motor with gear (parameter 050). In di erent
programs can di erent foot pressure be applied. You have the choice between three operation modes (parameter 054).
Operation mode: 1 = OFF
2 = CONSTANT
3 = 1-100%
ADVICE!
When sewing operations are done where the foot pressure is used to keep the material in position (e.g. piping), it is
advisable to use operation mode 1 (OFF). Operation mode 2 (CONSTANT) will lead to a negativ result. The material
thickness recognition will prevent positioning the piping.
050 Foot pressure
054 Dynamic foot pressure
07/2020
46
VETRON 5300 - POST BED MACHINE - INSTRUCTION BOOK
DESCRIPTION
The maximum speed will be entered here.
Here the stitches are set which are required for a soft start.
DESCRIPTION
Foot pressure is generated like on a conventional machine.
Can be di erent depending on the program.
The foot pressure will be constant on all material thicknesses. The material thickness recog-
nition will make sure that the foot pressure control that you have a constant foot pressure.
The foot pressure will be increased with increased sewing speed. Low percentage will
increase the pressure only weak. High percentage will increase the pressure stronger.
You can set the foot pressure for the program here. Comparable to a conventional
machine.
The following functions are available:
Function 1 = OFF
Function 2 = CONST
Function 3 = %
1
4
2
3
Advertisement
Table of Contents
