Table of Contents
Advertisement
02. MACHINE DESCRIPTION
10. DIRECT ACCESS
NOTICE!
It is possible to create operator´s direct access to one program parameter via the control
panel.
The direct access parameter is permanently shown in the display. The manipulations by
the operator are not saved in the program and will be reset after program change or when
the machine is turned o .
10
By turning the JOG KEY
The following parameters can be displayed:
» OFF
» Thread tension
» Stitch length
» Maximum speed
» Top feed stroke
» Top feed pressure
» Bobbin thread counter (only display)
» Edge guide distance
» Current sewing speed (only display)
» Current needle position in degrees (only display)
07/2020
20
VETRON 5400 - CYLINDER ARM MACHINE - INSTRUCTION BOOK
P
000
T
E T
S
the value can be adjusted directly.
30%
ESC
1
Advertisement
Table of Contents
