P
000
30%
T
E T
S
NOTE!
It is possible to create operator´s direct access to one program parameter via the control panel.
It is permanently shown in the display. The manipulations by the operator are not saved in the
program and will be reseted after program change or machine power o .
10
By turning the JOG KEY
The following parameters can be displayed:
OFF
»
Thread tension
»
Stitch length
»
Maximum speed
»
Top feed stroke
»
Top feed pressure
»
Bobbin thread counter (only display)
»
Edge guide distance
»
Current sewing speed (only display)
»
Current needle position in degrees (only display).
INSTRUCTION BOOK
ESC
the value can be adjusted directly.
11. DIRECT ACCESS
10
INSTRUCTION BOOK VETRON 5000 15