VETRON 5300 Instruction Book page 33

03. OPERATION OF THE MACHINE
1
DANGER! RISK OF INJURY!
Push the X-button at the machine head, the red light illuminates showing the active
"BLOCKED MODE", or turn the machine o .
Failure to comply produces a risk of injury in case of an unintentional machine
operation.
The safety clutch is integrated in the main drive module to protect the hook from damage.
Causes of damage could be for example thread jamming, needle breakage or incorrect operation.
If the safety clutch has released, perform the following procedure:
01. Turn the machine o at the main switch.
02. Remove the cause of the disorder.
03. Tilt the machine to the back, open the right cover to get access to the mechanical handwheel.
04. Take the 3 mm allen key of the accessories and stick it in screw
Turn the handwheel until the key is touching the machine housing (picture left).
05. Take the 5 mm allen key of the accessories and put it in the handwheel gap (picture right).
Turn the handwheel until the safety clutch is noticeably engaging.
06. Check the needle bar rise. (refer to chapter 03.12. of the adjustment manual).
If confirmed, the machine is ready for use again.
NOTICE!
Push the X-button or switch on the machine again and follow the instructions
displayed on the control panel.
06. ENGAGING THE SAFETY CLUTCH
VETRON 5300 - POST BED MACHINE - INSTRUCTION BOOK
1
.
07/2020
31