VETRON 5300 Instruction Book page 31

1
5
01. Push the X-button at the machine head, the red light illuminates showing
02. Open the hook cover. Fold up the tab
03. Insert the filled bobbin. Check the correct direction by pulling the thread end
04. Pass the bobbin thread through the slot
05. The bobbin thread tension can be adjusted at screw
03. OPERATION OF THE MACHINE
04. EXCHANGING THE BOBBIN AND ADJUSTING THE BOBBIN THREAD TENSION
2
3
4
CAUTION! RISK OF INJURY!
Push the X-button at the machine head, the red light illuminates showing the active
"BLOCKED MODE", or turn the machine o before removing the bobbin. Failure to
comply produces a risk of injury in case of an unintentional machine operation.
If the machine is equipped with the special feature "BOBBIN COVER DETECTION" it
automatically enters the "BLOCKED MODE" after opening the bobbin cover.
the active "BLOCKED MODE", or turn the machine o .
and assuring the rotation of the bobbin is counter-clockwise.
and pull it out of the thread guide
NOTICE!
Push the X-button or switch the machine on again and follow the instructions
displayed on the control panel.
1
5
1 and remove the bobbin
3 , then pass the tension spring below
1
5 . Close the tab and the hook cover.
.
4
VETRON 5300 - POST BED MACHINE - INSTRUCTION BOOK
(1- / 2- NEEDLE)
2
3
4
2 .
07/2020
29