P
000
T
E T
S
NOTE!
It is possible to create operator´s direct access to one program parameter via the
control panel.
The direct access parameter is permanently shown in the display. The manipulations
by the operator are not saved in the program and will be reset after program change
or when the machine is turned o .
10
By turning the JOG KEY
The following parameters can be displayed:
OFF
» Thread tension
» Stitch length
» Maximum speed
» Top feed stroke
» Top feed pressure
» Bobbin thread counter (only display)
» Edge guide distance
» Current sewing speed (only display)
» Current needle position in degrees (only display).
INSTRUCTION BOOK
30%
ESC
the value can be adjusted directly.
11. DIRECT ACCESS
10
VETRON 5000/5100 - FLAT BED MACHINE
08/2017
15