Electrical Connection - Miele PW 6321 EL Installations Plan

The washing machine must be set up on a completely level, horizontal
and firm surface with the minimum stated load bearing capacity (see
"Technical data").
Tip: A concrete floor is the most suitable installation surface. It is far
less prone to vibration during the spin cycle than wooden floorboards
or a carpeted surface.
The floor load created by the washing machine is the load exerted by
the area of the machine in contact with and transferred to the install-
ation surface.
The washing machine requires a gap of at least 50 mm on each side
to allow for movement during operation. Please ensure a minimum
distance of 400 mm is maintained between the rear of the appliance
and the rear wall.
The washing machine must not be installed on a carpeted floor.
The feet of the washing machine must be secured to the fastening
points on the floor using the fittings supplied.
The fittings supplied are for bolting the machine to a concrete floor. If
other floor types are present at the installation site, the fastening ma-
terial must be ordered by the customer.

Electrical connection

The electrical connection must only be carried out by a qualified
electrician who must ensure that all electrical work is carried out in
accordance with applicable electrical regulations and standards (BS
7671 in the UK).
This washing machine must be connected to an electrical mains

supply that complies with local and national regulations. Please also
observe your insurance and energy supplier's regulations as well as
any health and safety at work regulations.
The required voltage, connected load and fusing rating can be found

on the data plate on the washing machine. Before connecting the ma-
chine to the power supply, please ensure that the mains supply
voltage complies with the values given on the data plate.
Connection to a supply voltage other than the one quoted on the
data plate can lead to functional faults and damage the washing
machine!
If more than one voltage is quoted on the data plate, the washing
machine can be converted for connection to the voltages stated.
Conversion to a different voltage must only be carried out by a

Miele Service engineer or by an authorised Service Partner. The wiring
instructions given on the wiring diagram must be followed.
en - Installation notes
5