Table of Contents
Advertisement
Cancel with fault code
If a programme is cancelled and a fault code appears, e.g.
represents a number), there could be a serious technical fault.
In the event of a programme being cancelled and a fault code being shown:
Switch the washer-disinfector off using the button.
Wait approximately 10 seconds before switching the machine on again with the
button.
Acknowledge the fault code by entering your PIN code.
Start the previously selected programme again.
If the same message appears again:
Make a note of the error message.
Switch the washer-disinfector off using the button.
Contact the Miele Customer Service Department.
Please also read the notes regarding the following fault codes.
Problem
Fault 403-405
Fault 406–408
Fault 412–414
Fault 422
Cause and remedy
A programme has been cancelled because water intake by
the machine was insufficient or severely restricted.
Open the stopcocks fully.
Follow the additional information given in the
water inlet
message.
A programme was cancelled because the water flow rate is
insufficient.
Check whether the stopcocks are fully opened.
Please refer to the information regarding minimum flow
pressure in "Connection to the water supply" and
"Technical data".
Check the filters in the water supply.
In this instance, please contact the Miele Customer
Service Department for advice.
A programme was cancelled because the water flow rate is
too high.
Refer to the information regarding recommended
maximum flow pressure and maximum permissible static
water pressure in "Connection to the water supply" and
"Technical data".
In this instance, please contact the Miele Customer
Service Department for advice.
A programme was cancelled because the conductivity of
the supplied DI water is too high.
Check your system for DI water.
Problem solving guide
Fault XXX
(where XXX
Check
127
Advertisement
Table of Contents
