Cancel With Fault Code - Miele PG 8591 Operating Instructions Manual

Problem solving guide

Cancel with fault code

If a programme is cancelled and a fault code appears, e. g.
represents a number), there could be a serious technical fault.
In the event of a programme being cancelled and a fault number being shown:
Switch the machine off using the  button.

Wait approximately 10 seconds before switching the machine on again with the 

button.
Acknowledge the fault code by entering your lock code.

Start the previously selected programme again.

If the same message appears again:
Make a note of the fault message

Switch the machine off using the  button.

Contact the Miele Service Department.

Please also read the notes regarding the following fault numbers:
Problem
Fault 403-405
Fault 406-408
Fault 412-414
Fault 432
Fault 433
118
Cause and remedy
A programme has been cancelled because water intake by
the machine was insufficient or severely restricted.
Open the stopcocks fully.

Follow the further information given in the

inlet
message.
A programme was cancelled because the water intake
volume is insufficient.
Check whether the stopcocks are fully opened.

Refer to the information regarding minimum flow

pressure in "Plumbing" and "Technical data".
Check the filter in the water inlet.

Contact Miele Service for advice.

A programme was cancelled because the water intake
volume is too high.
Refer to the information regarding recommended

maximum flow pressure and maximum permissible static
water pressure in "Plumbing" and "Technical data".
Contact Miele Service for advice.

The door was opened using the emergency release.
See "Opening the door using the emergency release".

Protruding wash load items are preventing the door from
being closed properly by the Comfort lock.
Sort the wash load so that that it does not obstruct the

door.
Close the door.

Fault XXX
(whereby XXX
Check water