Network Settings - Cisco Service Manual Service Manual

Cisco TelePresence SX20 Quick Set
Contents

Network settings

Network [1..1] IPStack
Select which internet protocols the system will support.
NOTE: Restart the system after changing this setting.
Requires user role: ADMIN
Value space: <IPv4/IPv6>
IPv4: IP version 4 is used for the SIP and H323 calls.
IPv6: IP version 6 is used for the SIP and H323 calls.
Example:
Network 1 IPStack: IPv4
Network [1..1] Assignment
Define how the system will obtain its IPv4 address, subnet mask and gateway address. This
setting only applies to systems on IPv4 networks.
Requires user role: ADMIN
Value space: <Static/DHCP>
Static: The addresses must be configured manually using the Network IPv4 Address,
Network IPv4 Gateway and Network IPv4 SubnetMask settings (static addresses).
DHCP: The system addresses are automatically assigned by the DHCP server.
Example:
Network 1 Assignment: DHCP
Network [1..1] IPv4 Address
Enter the static IPv4 network address for the system. This setting is only applicable when
Network Assignment is set to Static.
Requires user role: ADMIN
Value space: <S: 0, 64>
Format: Only the valid IPv4 address format is accepted.
Example:
Network 1 IPv4 Address: "192.0.2.0"
D14908.02 SX20 Administrator Guide TC6.0, JANUARY 2013.
Introduction Web interface System settings System settings
Network [1..1] IPv4 Gateway
Define the IPv4 network gateway. This setting is only applicable when the Network Assignment
is set to Static.
Requires user role: ADMIN
Value space: <S: 0, 64>
Format: Only the valid IPv4 address format is accepted.
Example:
Network 1 IPv4 Gateway: "192.0.2.0"
Network [1..1] IPv4 SubnetMask
Define the IPv4 network subnet mask. This setting is only applicable when the Network
Assignment is set to Static.
Requires user role: ADMIN
Value space: <S: 0, 64>
Format: Only the valid IPv4 address format is accepted.
Example:
Network 1 IPv4 SubnetMask: "255.255.255.0"
Network [1..1] IPv6 Assignment
Define how the system will obtain its IPv6 address and the default gateway address. This
setting only applies to systems on IPv6 networks.
Requires user role: ADMIN
Value space: <Static/DHCPv6/Autoconf>
Static: The codec and gateway IP-addresses must be configured manually using the
Network IPv6 Address and Network IPv6 Gateway settings. The options, for example NTP
and DNS server addresses, must either be set manually or obtained from a DHCPv6 server.
The Network IPv6 DHCPOptions setting determines which method to use.
DHCPv6: All IPv6 addresses, including options, will be obtained from a DHCPv6 server. See
RFC3315 for a detailed description. The Network IPv6 DHCPOptions setting will be ignored.
Autoconf: Enable IPv6 stateless autoconfiguration of the IPv6 network interface. See
RFC4862 for a detailed description. The options, for example NTP and DNS server
addresses, must either be set manually or obtained from a DHCPv6 server. The Network
IPv6 DHCPOptions setting determines which method to use.
Example:
Network 1 IPv6 Assignment: Autoconf
www.cisco.com — Copyright © 2012-2013 Cisco Systems, Inc. All rights reserved.
63
Administrator Guide
Setting passwords Appendices