Assa Abloy Norton 5700P Series Installation Instructions Manual page 10

Install Arm
A. Mount forearm shoe to door.
1.
B. Install main arm to operator.
1.
2.
C. Preload arm.
1.
2.
3.
4.
5.
6.
10
Using previously prepared holes in
door, install two (2) 1/4-20 x 1-5/8"
screws through shoe and into sex
bolts. (Figure 18)
NOTE: Orient shoe with short side
of shoe toward hinge.
Insert main arm onto pinion shaft of
unit at 90° angle to frame.
(Figure 19)
NOTE: Align arm mark "S" with
flat corner of pinion shaft square.
(Figure 20)
Secure main arm to pinion with
1/4-20 x 1/2" flange head screw.
Open door.
Remove 1/4-20 hex head screw on
forearm adjusting rod. (Figure 21)
Insert adjusting rod into adjusting
tube. (Figure 21)
Reinstall 1/4-20 screw and leave
loose.
Rotate main arm in direction away
from hinge edge until adjusting rod
and tube are perpendicular (at 90°
angle) to frame.
Tighten 1/4-20 hex head screw on
adjusting rod to secure arm in this
new position.
Approved 2020-01-27
5700P Series Power Operator - PUSH SIDE Installation
Hinge
Short Side
of Shoe
Figure 18
View from ceiling looking downward
Figure 19
Figure 20
View from ceiling looking downward
Figure 21
Copyright © 2016, 2019-2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
View from ceiling looking downward
80-9357-0009-020 Rev 7 01/20