Before You Begin - Assa Abloy Norton 5700P Series Installation Instructions Manual

Before You Begin

• All dimensions are given in inches
(millimeters). DO NOT scale drawings.
• Thickness recommended for reinforcements
in hollow metal doors and frames is charted.
• Template information is based on use of 5"
(127mm) maximum width butt hinges or
3/4" (19mm) offset pivots.
• Maximum frame reveal is 1/8" (3mm) for
PULL units and 2-5/8" - 6-3/4" (67-171mm)
for PUSH units.
• Before beginning the installation, verify that
the door frame is properly reinforced and is
well anchored in the wall. Frame header must
be straight - without warp or bow.
• Unreinforced hollow metal frames and
aluminum frames should be prepared and
fitted with 1/4-20 blind rivet nuts, furnished
by others.
• Concealed switch or sensor wires should be
pulled to the frame before proceeding.
Fasteners for Frame:
• Hollow metal and aluminum: 1/4-20 Machine
screws
• Wood:
No. 14 x 2-3/4" (70mm) sheet metal screws
Fasteners for Door:
• 1/4-20 Machine screws
3/8 x 1-5/8" sex nut
Mounting Hardware
4
Unit:
14 x 2-3/4" Sheet Metal Screw
Unit:
1/4-20 x 1" Flat Head Machine Screw
Track or Arm:
Sex Nut and Bolt (SNB)
(optional)
Approved 2020-01-27
Templating based on 1/8" gap
between door and frame.
Hollow Metal Door Frame Reinforcing
Frame Material
12 Ga.
.105
(2.66)
14 Ga.
.075
(1.90)
16 Ga.
.060
(1.52)
18 Ga.
.048
(1.21)
Door or Frame
Wood
Hollow Metal or
Aluminum
Hollow Metal
Aluminum or Wood
Copyright © 2016, 2019-2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
5700P Series Power Operator
Frame
Door
1/8"
(3)
Reinforcing
Recommended Min. Required
12 Ga. 18 Ga.
.105 .048
(2.66) (1.21)
10 Ga. 12 Ga.
.134 .105
(3.41) (2.66)
10 Ga. 12 Ga.
.134 .105
(3.41) (2.66)
8 Ga. 10 Ga.
.164 .134
(4.18) (3.41)
Drill
3/16" (4.76mm)
Drill #7 (.201 dia. or 5.10mm)
Tap 1/4-20
9/32" (7.00mm) thru
3/8" (9.50mm) door face opposite to closer
3/8" (9.50mm) thru
80-9357-0009-020 Rev 7 01/20