Assa Abloy Norton 5700P Series Installation Instructions Manual page 9

5700P Series Power Operator - PUSH SIDE Installation
B. Prepare door for arm assembly.
1. Using template on page 20, locate and
prepare two (2) 3/8" (9.5mm) holes in
door for sex bolts. (Figure 16)
NOTE: Standard units are supplied
with sex nuts and bolts for 1-3/4"
(44mm) thick door. Sex nuts and
bolts for other door thicknesses are
available to order.
Install Operator
A. Remove cover from unit and set cover and screws aside.
B. Mount unit to frame. (Figure 17)
NOTE: Select Concealed or Surface option.
Concealed Class 2 Low Voltage Only:
• Connect conduit to frame side of backplate.
• Secure unit to frame with six (6) screws.
Surface Class 2 Low Voltage Only:
OR
• Secure unit to frame with six (6) screws.
• Mount conduit bracket (found in screw pack)
to unit backplate with two (2) provided
screws.
• Connect wiring conduit to bracket.
Copyright © 2016, 2019-2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9357-0009-020 Rev 7 01/20
Approved 2020-01-27
Door Opening Angle
Up to 110°
111° to 170°
Left Hand Shown
Figure 16
Figure 17
Dim A
12" (305mm)
9-1/2" (241mm)
9