Deleting A Network Time Protocol Server; Changing The Time Zone; Changing The Time Format; Automatically Adjusting The Time For Daylight Saving Time - Christie CP4315-RGB User Manual

Deleting a network time protocol server

Remove a network time protocol (NTP) server if you do not need to synchronize the time on all
installed projectors in the same region.
1. In the left navigation menu, select Service Setup > Time Setup.
2. Switch to the NTP Server tab.
3. If network time protocol (NTP) time synchronization is not active, select Time Sync using
NTP Server.
The color of the slider changes to green to indicate it is active.
4. In the NTP Server Address list, select an NTP server.
5. Select Delete.
6. At the confirmation dialog, select Delete.

Changing the time zone

Change the time zone settings to make the projector time match the local time zone.
1. In the left navigation menu, select Service Setup > Time Setup.
2. Select the Time Zone tab.
3. In the Region list, select a region.
4. In the Time Zone list, select the time zone.
5. Select Save.

Changing the time format

You can use the 12-hour or 24-hour format to display projector time. The 24-hour format reduces
ambiguity.
1. In the left navigation menu, select Service Setup > Preferences.
2. Select General.
3. In the System area, select a time format option:
• To use the 12-hour format, select 12 Hours.
• To use the 24-hour format, select 24 Hours.
Automatically adjusting the time for Daylight
Saving Time
With automatically adjusted time settings, there is no need to update the projector time when
Daylight Saving Time occurs.
1. In the left navigation menu, select Service Setup > Time Setup.
2. Select the Time Zone tab.
Cinema 4K-RGB User Guide–CP4315-RGB, CP4320-RGB, CP4325-RGB, CP4330-RGB
020-102712-06 Rev. 1 (03-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Operating the projector
24