Configuring The Projector Time; Adding A Network Time Protocol Server; Deleting A Network Time Protocol Server - Christie CP2309-RGB User Manual

Configuring the
projector time
Learn how to set the time on the projector.

Adding a network time protocol server

Add a network time protocol (NTP) server to synchronize the time on all installed projectors in the
same region.
1. In the left navigation menu, select Service Setup > Time Setup.
2. Switch to the NTP Server tab.
3. Select the Time Sync using NTP Server slider.
The color of the slider changes to green to indicate it is active.
4. Select + New NTP Server.
5. Select a local or a public NTP server:
• To use a local NTP server, select Local Server and type the IP address in the IP Address
field.
• To use a public NTP server, select Public Server and complete the Country and Server
fields.
6. To test the connection, select Test.
7. Select Add.

Deleting a network time protocol server

Remove a network time protocol (NTP) server if you do not need to synchronize the time on all
installed projectors in the same region.
1. In the left navigation menu, select Service Setup > Time Setup.
2. Switch to the NTP Server tab.
3. If network time protocol (NTP) time synchronization is not active, select Time Sync using
NTP Server.
The color of the slider changes to green to indicate it is active.
4. In the NTP Server Address list, select an NTP server.
5. Select Delete.
6. At the confirmation dialog, select Delete.
CP2309-RGB User Guide
020-103081-02 Rev. 1 (03-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
23