Install The Rs1 - Raven RS1 Installation Manual

5. Plug the connectors labeled "HDU" on the RS1/HDU harness into the appropriate connectors on the HDU.
6. Route the connector labeled "RS1" up to the rear of the cab roof.

INSTALL THE RS1

1. Assemble the latch, plug, rubber washer, and latch nut through the latch hole on RS1 mounting plate.
FIGURE 8. Latch Assembly
2. Mount the RS1 base plate to the RS1 unit using the four bolts provided. It should be mounted so the mounting
tabs are to the right and the latch is to the left.
FIGURE 9. Mounting RS1 Unit to Mounting Bracket
Mounting Tabs
3. Assemble the four pieces of the RS1 roof bracket (as shown in Figure 10 on page 16). Use the eight provided
3/8" x 1" bolts and lock washers to secure the assembly together.
Cab Component Installation: Install the HDU Node
Front of RS1
Unit
CAB COMPONENT INSTALLATION
RS 1 Mounting Plate
Latch
Plug
Latch Hole
Rubber Washer
Latch Nut
Mounting Latch
15