Raven RS1 Installation Manual page 14

CHAPTER 3
FIGURE 3. Rotary Sensor Installed
4. Install the rotary sensor assembly on the WAS mounting bracket (P/N 107-0172-228) using the supplied
hardware.
5. Using care to not move the sensor shaft, slide the WAS arm bracket (P/N 116-0159-671) onto the rotary sensor
shaft.
6. Insert the supplied set screw through the hole in the arm bracket, tightening it against the flat spot on the
sensor shaft.
7. Secure the WAS assembly to the machine's kingpin using the machine's bolt that was removed in step 3.
8. Install the 1/2"-13 hex nut (P/N 312-1001-166) on the 1/2"-13 x 7" hex bolt (P/N 311-0058-113).
9. Insert the head of the bolt into the slot on the WAS arm bracket and position the end of the bolt over the hole
in the axle.
10. Screw the bolt into the hole in the axle until the head of the bolt rests on the WAS arm bracket.
11. Tighten the nut on the end of the bolt until it is snug against the axle.
10 RoGator RG900, RG1100, and RG1300 Model Year 2012-2014 (Steer-Ready) - RS1/HDU Installation Manual