Table of Contents
Advertisement
CHAPTER
5
INSTALL THE RS1 UNIT
FIGURE 1. Mounting Bracket Installed
1. Install the RS1 mounting bracket (P/N 107-0172-498) on the bottom of the RS1 unit using four 1/4"-20 x 1/2" flat
head machine screws (P/N 311-0003-041).
FIGURE 2. Machine's Existing Receiver Mounting Bracket
2. Install the RS1 mounting bracket (P/N 116-0159-803) on the front of the cab roof using the machine's existing
hardware.
NOTE:
The RS1 mounting bracket should be installed so that the latch is on the left side.
016-5032-103 Rev. D
C AB COMPONENT
C H A P T E R 5
INSTALLATION
25
Advertisement
Table of Contents
