Cab Component Installation; Install The Rs1/Hdu Harness - Raven RS1 Installation Manual

CHAPTER
4

INSTALL THE RS1/HDU HARNESS

1. Remove the access panel cover on the outside right-rear corner of the cab.
NOTE: If SmarTrax is installed on the machine, remove the SmarTrax harness.
FIGURE 1. SmarTrax Node Harness to be Removed and Machine Access Panel
2. Route the two 12-pin Deutsch connectors labeled "HDU" on the RS1/HDU cable (P/N 115-4010-161) into the
machines cab, through the access hole.
3. Remove the bulkhead plug from the cab floor in the right-rear corner of the cab.
FIGURE 2. STRAX BLKHD Connection
STRAX BLKHD
Connection
4. Install the Valve Bulkhead connector in the hole.
Cab Component Installation: Install the RS1/HDU Harness
C AB COMPONENT
C H A P T E R 4
INSTALLATION
11