Install The (Optional) Analog Video Kit; Mount The Analog Display To Cr7 - Raven VSN Installation Manual

INSTALL THE (OPTIONAL) ANALOG VIDEO KIT

If a CR7™ is used in the machine, the analog video kit (P/N 117-2020-007) may be useful for viewing the video feed
from VSN®. The CR7™ does not have an analog video input, so this auxiliary display is used.
FIGURE 15. Standalone Height Sensor

MOUNT THE ANALOG DISPLAY TO CR7™

1. Remove the screws securing the RAM mount on the rear of the CR7.
2. Using the washers provided, place a washer between the CR7 and the bracket.
3. Place a washer on the back of the bracket and use the existing screws that held the RAM mount in place.
IMPORTANT: Two washers are used on each of the CR7 screws to ensure proper length. Torque between 9 and 11 in-lbs.
4. Using the additional hardware, mount the RAM mount to the bracket.
5. Mount the axillary display bracket to the bracket as seen in Figure 16.
FIGURE 16. Mounted to Bracket
NOTE: Larger RAM connectors and mounts are provided to account for the extra weight.
Installation: Install the (Optional) Analog Video Kit
INSTALLATION
17