Ping Generator Options; Monitor - Fortinet FortiGate FortiGate-1000 Administration Manual
Fortinet fortigate fortigate-1000: user guide
Hide thumbs
Also See for FortiGate FortiGate-1000:
- Install manual (66 pages) ,
- Installation manual (56 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
VPN
Ping generator options
Monitor
FortiGate-1000 Administration Guide
Figure 130:Ping generator
Enable
Source IP 1
Destination IP 1
Source IP 2
Destination IP 2
To configure the ping generator
1
Go to VPN > IPSEC > Ping Generator.
2
Select Enable.
3
In the Source IP 1 box, type the private IP address from which traffic may originate
locally.
4
In the Destination IP 1 box, enter the IP address of the computer to ping at the remote
end of the VPN tunnel.
5
If you want to enable a second ping generator, repeat Steps 3 and 4 for the Source IP
2 and Destination IP 2 settings.
6
Select Apply.
You can use the IPSec VPN monitor to view connections to IPSec VPN tunnels. The
display provides information about tunnel connections including addressing, proxy
IDs, and status information.
To monitor a VPN tunnel
1
Go to VPN > IPSEC > Monitor.
You can establish or take down a VPN tunnel manually through the Monitor tab.
To establish or take down a VPN tunnel
1
Go to VPN > IPSEC > Monitor.
Disable or enable pinging between the specified source and destination
addresses.
Enter the private IP address from which traffic may originate locally.
Enter the IP address of the computer to ping at the remote end of the VPN
tunnel.
If you want to generate traffic on a second VPN tunnel simultaneously,
enter a second private IP address from which traffic may originate locally.
If you want to generate traffic on a second VPN tunnel simultaneously,
enter the IP address of the computer to ping at the remote end of the
second VPN tunnel.
01-28006-0009-20041105
Monitor
259
Advertisement
Table of Contents
