Ping Generator Options; Monitor - Fortinet FortiGate FortiGate-5001 Administration Manual

Monitor

Ping generator options

Monitor
268
4 In the Destination IP 1 field, enter the IP address of a remote computer:
• For a peer-to-peer configuration, the destination address is the private IP address
of a server or host behind the remote VPN peer (for example, 172.16.5.1/32).
• For a dialup-client or Internet-browsing configuration where the remote VPN client
is configured to acquire a virtual IP address, the destination address must
correspond to the virtual IP address that can be acquired.
5 If you want to enable a second ping generator, repeat Steps 3 and 4 for the Source IP
2 and Destination IP 2 settings.
6 Select Apply.
Figure 136:Ping generator
Enable
Source IP 1
Destination IP 1
Source IP 2
Destination IP 2
You can use the monitor to view activity on IPSec VPN tunnels and start or stop those
tunnels. The display provides a list of addresses, proxy IDs, and timeout information
for all active tunnels.
To view active tunnels
1 Go to VPN > IPSEC > Monitor.
To interpret the display, see the following sections:
• "Dialup monitor" on page 269
• "Static IP and dynamic DNS monitor" on page 269
Select the option to ping the specified destination address using the
specified source address.
Enter the IP address from which traffic may originate locally.
Enter the IP address of the remote computer to ping.
If you want to generate traffic on a second VPN tunnel simultaneously,
enter a second IP address from which traffic may originate locally.
Enter the IP address of the second computer to ping
01-28008-0013-20050204
VPN
Fortinet Inc.