Configuring Virtual Domains; Adding Interfaces, Vlan Subinterfaces, And Zones To A Virtual Domain - Fortinet FortiGate FortiGate-1000 Administration Manual
Fortinet fortigate fortigate-1000: user guide
Hide thumbs
Also See for FortiGate FortiGate-1000:
- Install manual (66 pages) ,
- Installation manual (56 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
Configuring virtual domains
Configuring virtual domains
Adding interfaces, VLAN subinterfaces, and zones to a virtual domain
138
To select a management virtual domain
The following procedure applies to NAT/Route mode only.
1
Go to System > Virtual Domain > Virtual Domains.
2
Select Change beside the listed Management virtual domain.
3
Choose the management domain and select OK.
Note: You cannot delete a management virtual domain. You must first select a different domain
for system management.
To select a management virtual domain and add a management IP
The following procedure applies to Transparent mode only.
1
Go to System > Network > Management.
2
Enter the Management IP/Netmask.
3
Enter the Default Gateway.
4
Select the Management Virtual Domain.
5
Select Apply.
The FortiGate unit displays the following message:
Management IP address was changed. Click here to redirect.
6
Click on the message to connect to the new Management IP.
The following procedures explain how to configure virtual domains:
•
Adding interfaces, VLAN subinterfaces, and zones to a virtual domain
•
Configuring routing for a virtual domain
•
Configuring firewall policies for a virtual domain
•
Configuring IPSec VPN for a virtual domain
To add physical interfaces to a virtual domain
A virtual domain must contain at least two interfaces. These can be physical
interfaces or VLAN interfaces.
By default all physical interfaces are in the root virtual domain and the following
procedure describes how to move a physical interface from one virtual domain to
another. You cannot remove a physical interface from a virtual domain if firewall
policies have been added for it. Delete the firewall policies or remove the interface
from the firewall policies first. If the interface has been added to a zone, it is removed
from the zone when you move it to a different virtual domain.
1
Go to System > Network > Interface.
01-28006-0009-20041105
System virtual domain
Fortinet Inc.
Advertisement
Table of Contents
