IBM PS703 Service Manual page 88

Table 18. BA000010 to BA400002 Partition firmware SRCs (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v See Chapter 3, "Parts listing, type 7891," on page 225 to determine which components are CRUs and which
components are FRUs.
Error code
BA060070
BA060071
BA060072
BA060075
BA060200
BA060201
BA060202
BA060300
BA07xxxx
76
Power Systems: Problem Determination and Service Guide for the IBM PS703 (7891-73X) and PS704 (7891-74X)
Description
The operating system does not support
this system's processor(s)
An invalid number of vectors was
received from the operating system
Client-arch-support hcall error
Client-arch-support firmware error
Failed to set the operating system boot
list from the management module boot
list
Failed to read the VPD "boot path" field
value
Failed to update the VPD with the new
"boot path" field value
An I/O error on the adapter from which
the boot was attempted prevented the
operating system from being booted.
self configuring SCSI device (SCSD)
controller failure
Action
Boot a supported version of the operating
system.
Boot a supported version of the operating
system.
1. Go to "Checkout procedure" on page 176.
2. Replace the system-board, as described in
"Replacing the FRU system-board and
chassis assembly" on page 264.
1. Go to "Checkout procedure" on page 176.
2. Replace the system-board, as described in
"Replacing the FRU system-board and
chassis assembly" on page 264.
1. Using the SMS menus, set the boot list to
the default boot list.
2. Shut down; then, start up the blade server.
3. Use SMS menus to customize the boot list
as required.
4. If the problem persists:
a. Go to "Checkout procedure" on page
176.
b. Replace the system-board, as described
in "Replacing the FRU system-board
and chassis assembly" on page 264.
1. Go to "Checkout procedure" on page 176.
2. Replace the system-board, as described in
"Replacing the FRU system-board and
chassis assembly" on page 264.
1. Go to "Checkout procedure" on page 176.
2. Replace the system-board, as described in
"Replacing the FRU system-board and
chassis assembly" on page 264.
1. Using the SMS menus, select another
adapter from which to boot the operating
system, and reboot the system.
2. Attempt to reboot the system.
3. Go to "Boot problem resolution" on page
182.
1. Go to "Checkout procedure" on page 176.
2. Replace the system-board, as described in
"Replacing the FRU system-board and
chassis assembly" on page 264.