Table of Contents
Advertisement
9. If you are servicing a base unit and not an expansion unit, install the bezel assembly. See "Installing
the bezel assembly" on page 241 for instructions.
10. Install and close the blade server cover. See "Installing and closing the blade server cover" on page
235.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power source. Always
replace the blade server cover before installing the blade server.
11. Write the machine type, model number, and serial number of the blade server on the repair
identification (RID) tag that comes with the replacement system-board and chassis assembly. This
information is on the identification label that is behind the control-panel door on the front of the
blade server.
Important: Completing the information on the RID tag ensures future entitlement for service.
12. Place the RID tag on the bottom of the blade server chassis.
13. Install the blade server into the BladeCenter unit. See "Installing the blade server in a BladeCenter
unit" on page 232.
14. Turn on the blade server.
15. Reset the system date and time through the operating system that you installed.
For additional information, see the documentation for your operating system.
Chapter 4. Removing and replacing blade server components
265
Advertisement
Table of Contents
